A network associate at NetworksHeaven needs to configure the switches and router given in the figure so that the hosts in VLAN3 and VLAN4 can communicate with eachother. Which two ethernet segments would need to be configured as trunk links? 1) A 2) B 3) C 4) D 5) E… read more →
Assume that SW-AC1 and SW-AC2 have default congurations. What will happen if PC-1 sends a broadcast? A. PC 1,2 and Fa0/0 interface of Router will receive the broadcast. B. PC 1,2,3,4 and the interface Fa0/0 of R1 will receive the broadcast. C. PC 1,2,3 and 4 will receive the broadcast.… read more →
Which of the following statements describe the network shown in the given picture? A. There is one broadcast domain in the network. B. There are three broadcast domains in the network C. There are twelve collision domains in the network. D. There are sixteen collision domains in the network.
Question: What are the two major benefits that can be acheived by using a Hierarchical Network Addressing Scheme ? A. Auto-negotiation of media rates. B. Efficient utilization of MAC addresses. C. Dedicated communications between devices. D. Reduces routing table entries. E. Ease of management and Troubleshooting.
Question: For which type of connection should a straight-through cable be used? A. Hub to Hub B. Router to PC C. Switch to Router D. Switch to Switch E. Switch to Hub
Question: Networks Heaven has initially configured all ports of a switch to be the member of VLAN 10. What will be the effect if switch ports are added to a new VLAN i.e., VLAN 12. Options: A. An addition collision domain will be created. B. More bandwidth will be required… read more →
Question: Networks Heaven has recently installed Cisco IP Phones in its office. Both the IP Phones and Computers are connected to the same device but they are on different networks to ensure the quality for the voice. Which device and technology is the best to meet the requirements? Options: A. … read more →
Question: Assuming that two devices X and Y are communicating properly and the device X is sending data to device Y. What order will be followed by Device X to encapsulate the data in the various protocol data units (PDUs)? Options: A. Data into Packet into Segment into Frame into… read more →