Cisco Vs Huawei CLI 5 – (Configuring a Serial Interface)

In this article, we will learn about configuring a serial interface on Cisco and Huawei devices. Configuring a synchronous serial interface includes setting physical and link layer parameters.
CISCO
NetworksHeaven> enable NetworksHeaven# configure terminal NetworksHeaven(config)# interface serial 1/0/0 NetworksHeaven(config-if)# ip address 1.1.1.1 255.0.0.0 NetworksHeaven(config-if)# encapsulation ppp NetworksHeaven(config-if)# clock rate 64000 NetworksHeaven(config-if)# no shutdown NetworksHeaven(config-if)# exit
HUAWEI
<NetworksHeaven> system-view [NetworksHeaven] interface  Serial 1/0/0 [NetworksHeaven -Serial1/0/0] ip address  1.1.1.1    8 [NetworksHeaven -Serial1/0/0] link-protocol ppp [NetworksHeaven -Serial1/0/0] baudrate  64000 [NetworksHeaven -Serial1/0/0] undo shutdown [NetworksHeaven -Serial1/0/0] quit [NetworksHeaven]

Cisco Vs Huawei CLI Commands in Slides